Facility

Important considerations:

1. When connecting the sensor, the colors of the cables must be respected, regardless of their order.

2. When removing the damaged sensor, it is important to correctly clean the pins where the new one will be placed, they can even be twisted with a needle nose pliers about 15 or 20 degrees to ensure good quality contact.

3. The computer only performs the measurement once the kick stand is raised (40 seconds later).

4. It is essential to carry out a full charge after changing the sensor so that it starts measuring correctly.

5. Calibration it's a must in all cases, although the sensor can be installed without performing it, which will generate a reading error.

6. The calibration can be carried out indistinctly, with the sensor outside or inside the tank and with it with or without fuel (it does not modify the calibration at all).